Openwrt wireless relay setup steps

In the process of using a wireless router, the longest thing to see is to directly mount the router behind the light cat to dial, and then separate the wifi to other devices for Internet access. However, in some cases, there are often special requirements. For example, it is possible that the router does not use wired access but uses wireless access. It is possible that we use this router to just amplify the signals of other routers. Maybe we use this router to relay other wireless signals and still be in the original subnet. Maybe our router is just used to connect the wifi to the desktop that can't use wifi. Maybe the router wants to hang a USB NIC to receive the weak wifi signal outside 500m.

Xiaobian introduces the OpenWrt/LEDE routing wireless relay setup tutorial here, based on OpenWrt Chaos Calmer 15.05.1 / LEDE 17.01.0 version introduction

The method and steps are as follows:

Take Windows10 as an example, use the network cable to connect the computer and the router lan port. The lan port is the port where the computer is connected to the Internet. You know! Then check the computer network center

Press win+x to enter the control panel, then enter the network center and check the network IP settings.

If the network is not recognized, set the IP to 192.168.1.22

Open the browser and enter 192.168.1.1. Press Enter to enter the routing login page. The default username: root password: root Please modify the other gateway and username passwords.